How Make A Water Rocket In Easy Way

7:00 AM Fun Science 0 Comments

Making A Water Rocket

Today I'm going to show you how to make a water rocket.It's pretty easy but don't get screwed while you are making the rocket launcher.So be careful and fly the rocket safely under the inspection of a elder.

First You Will Need These Materials

1/2 inch PVC pipe about 8 ft
2 X T-bonds
4 X End Caps
Bicycle Valve
2 X 2L Bottle
Pair of scissors
PVC Glue
Dutch Tape
Knife(Be careful)

Step 1

First get the 2L bottel and cut the top edge like down below to make the nose of the rocket.

Step 2

Then glue that piece to the other bottle's footer.Then remove the cap of the uncut bottle and make a hole which is suitable to place the bicycle valve.Be careful on this point because after placing the bicycle valve the hole should be 100% air-tight.Otherwise the rocket won't launch if the pressure leaks.If the pressure is leaking add some PVC glue and seal around the hole from inside and outside.

Step 3

Now set the cap tho the bottle again.Make some fins to the rocket and glue them to the rocket like this.(You should not cut the  bottle like this,only you have to do is glue them to the rocket)

So now the rocket is finished.Now it's looks like this one..

Now it's the time to make the launcher.It is harder to explain like this.So I believe it will be easy to under stand from a video clip.Don't be afraid,just easy steps and just carry on.

So lets see how to make the rocket launcher 

So now the Water Rocket is finished and it's the time to have a fun.As i said be careful,don't hurt others..Pump the air to the rocket and release it.
And I hope you will have a great fun..

Thank you for reading..
Please subscribe..